Products - Slot Cars - Lap Timer for Windows
|
|||
 Overview |
Pictures |
Dead Strip Option |
|
| Manual |
Videos |
Reed Switch Option |
|
| FAQ |
Troubleshooting |
Ir LED Bridge Option |
|
| Screen Shots |
Software Updates |
||
Installing infrared sensors
Follow these steps for the easiest way of installing sensors.
The advantages are perfect vertical installation of sensor and easy removal of
sensor from track.
Shown is a Ninco track but the same technique can be used for all plastic
tracks.
| #1 Put a big blob of hot glue on the underside of the track to build up the track thickness. |
 |
 |
#2 Let it cool for several hours then drill the hole for the sensor using a 1/8" drill bit. |
| #3 Clean the edge of hole with a bigger drill bit. |
 |
 |
#4 It will look like this On HO tracks the sensor is mounted between the rail and the slot |
| #5 Insert Sensor. It will fit snugly into the hole |
 |
 |
#6 Done!! You don't need to glue it in place. |
| #7 Completed
Secure the sensor cable under the table so weight of cable does not pull the sensors out of the holes. |
 |
